Some of Our Sources
- Web Designer Wall
- Just Creative
- Joshua Blankenship
- The Logo Smith
- Abduzeedo
- You The Designer
- Fuel Your Creativity
- Reencoded
- 24 Ways
- Specky Boy
Help Webnuz
Referal links:
January 24, 2019 06:50 pm
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/sZj_al46d8g/new-3d-printing-technique-is-100-times-faster-than-standard-3d-printers
New 3D Printing Technique Is 100 Times Faster Than Standard 3D Printers
A new 3D-printing technique could render a three-dimensional object in minutes instead of hours -- at up to 100 times current speeds. The experimental approach uses a vat of resin and some clever tricks with UV and blue LED lights (no lasers needed) to accelerate the printing process. From a report: The technique looks almost like a time-reverse film loop of an object dissolving in a reservoir of acid. But instead of acid, this reservoir contains a specially-designed resin that hardens when exposed to a particular shade of blue light. Crucially, that hardening (the technical term is polymerization) does not take place in the presence of a certain wavelength of UV light. The resin is also particularly absorbent at the wavelengths of both the blue and UV light. So the intensity of UV or blue light going in translates directly to the depth to which light will penetrate into the resin bath. The brighter the light beam, the further it penetrates and the further its effects (whether inhibiting polymerization in the case of UV light, or causing it in the case of blue light) will be felt in the bath along that particular light path. Timothy Scott, associate professor of chemical engineering at the University of Michigan, says the way to get a 3D-printed object out of this process is to send UV light through a glass-bottomed basin of resin. Then, at the same time, through that same glass window, send patterns of bright and dim blue light. If this printing process used only the blue light, it would immediately harden the first bit of resin it encounters in the basin -- the stuff just inside the glass. And so each successive layer of the object to be printed would need to be scraped or pulled off the window's surface -- a time-consuming and potentially destructive process.Read more of this story at Slashdot.
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/sZj_al46d8g/new-3d-printing-technique-is-100-times-faster-than-standard-3d-printers
Share this article:
Tweet
View Full Article
Slashdot
Slashdot was originally created in September of 1997 by Rob "CmdrTaco" Malda. Today it is owned by Geeknet, Inc..More About this Source Visit Slashdot