An Interest In:
Web News this Week
- April 26, 2024
- April 25, 2024
- April 24, 2024
- April 23, 2024
- April 22, 2024
- April 21, 2024
- April 20, 2024
July 16, 2018 07:07 am
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/WkpHcUw9ZYM/lockheed-martin-creates-its-largest-3d-printed-space-part-to-date
Lockheed Martin Creates Its Largest 3D-Printed Space Part To Date
Lockheed Martin has finished quality control tests for its largest 3D-printed space part to date: an enormous titanium dome meant to serve as caps for satellite fuel tanks. The component measures four feet in diameter. Engadget reports: Its previous largest qualified space part is an electronics enclosure that's around the size of a toaster. This dome is large enough to seal fuel tanks bigger than humans and, according to Lockheed Martin, big enough to hold 74.4 gallons of coffee or 530 donuts. Glazed, of course. Titanium is an ideal material for the industry, because it's lightweight and can withstand the harsh conditions of space travel. However, manufacturers end up wasting 80 percent of the material using traditional manufacturing techniques -- plus, each component could take years to build. Rick Ambrose, the company's executive VP, said they were able to cut down the total delivery timeline for a titanium fuel tank dome from two years to an incredibly impressive three months. "Our largest 3D-printed parts to date show we're committed to a future where we produce satellites twice as fast and at half the cost."Read more of this story at Slashdot.
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/WkpHcUw9ZYM/lockheed-martin-creates-its-largest-3d-printed-space-part-to-date
Share this article:
Tweet
View Full Article
Slashdot
Slashdot was originally created in September of 1997 by Rob "CmdrTaco" Malda. Today it is owned by Geeknet, Inc..More About this Source Visit Slashdot