An Interest In:
Web News this Week
- April 18, 2024
- April 17, 2024
- April 16, 2024
- April 15, 2024
- April 14, 2024
- April 13, 2024
- April 12, 2024
June 3, 2015 10:00 pm
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/pvP7TOZuKFM/making-an-ar-15-in-the-wired-san-francisco-office
Making an AR-15 In the Wired San Francisco Office
An anonymous reader writes: Wired's writer Andy Greenberg writes about his experience fabricating an AR-15 lower receiver with the Ghost Gunner CNC mill. (That's the same device that was demoed in a Slashdot video earlier this year.) Greenberg points out that CNC millng isn't new, but reports nonetheless: "Aside from a single brief hardware hiccup, it worked remarkably well. In fact, the Ghost Gunner worked so well that it may signal a new era in the gun control debate, one where the barrier to legally building an untraceable, durable, and deadly semiautomatic rifle has reached an unprecedented low point in cost and skill."Read more of this story at Slashdot.
Original Link: http://rss.slashdot.org/~r/Slashdot/slashdot/~3/pvP7TOZuKFM/making-an-ar-15-in-the-wired-san-francisco-office
Share this article:
Tweet
View Full Article
Slashdot
Slashdot was originally created in September of 1997 by Rob "CmdrTaco" Malda. Today it is owned by Geeknet, Inc..More About this Source Visit Slashdot